SAME DAY SHIPPING
— Order by 2pm EST.
Toggle Nav
Cart
Search
main product photo

Vickers KDG4V 3S 33C08A M U

Ask A Question

Description & Features

Designed for demanding industrial environments, the Vickers KDG4V 3S 33C08A M U is a direct-acting proportional valve rated at 8 litres per minute flow. It is available in three performance levels, ultra, high, and standard, allowing selection to match specific application requirements without over-specifying.

Fluorocarbon seals support compatibility with a broad range of hydraulic fluids, and plug-and-play functionality is built in to reduce commissioning time. Suitable applications span machine tool, press, marine and offshore, die casting and foundry, primary metal and paper processing, test equipment and simulation, and turbine control systems including wind, steam, and water.

SKU: 02-140083

Supplier Part Number (MPN): 02-140083

Specifications

Brand
Vickers by Danfoss
Actuator Type
Solenoid Controlled
Build Type
Spring Centered
Design Series
60 Series
Dimensions
8.64 in L x 1.81 in W x 3.58 in H
Domestic/Import
Domestic
Feedback Sensor
Without Feedback Sensor
Language
English
Manual Override
Plain
Media
Anti-Wear Hydraulic Oil, Non-Alkyl Based Phosphate Ester
Metering
Meter-In
Number of Stages
1
On Board Electronics
Without On Board Electronics
Performance
Standard
ProFX Compatible
Without ProFX Compatible
Reducer Module
Without Reducer Module
Reverse Flow Check
Without Reverse Flow Check
Seal Material
FKM
Segment Code
C
Series
KDG4V-3 60 Series
Spool Type
P Blocked, A and B to Tank
Symmetric Flow
With Symmetric Flow
Valve Mount Type
Subplate

Product Questions & Answers (1)

Question by: Glen A on Oct 10, 2025, 8:12 PM
three performance levels sounds good on paper, but what actually separates ultra from standard on something like this? trying to figure out if we need to spec up or if standard gets the job done for most press work
Answer by: Customer Support on Oct 12, 2025, 6:29 AM
Flow control precision and response characteristics are what typically shift between those tiers. The ultra level is built for applications where tight tolerances and repeatable positioning matter most, while standard covers general-purpose use where some variation is acceptable. For press work that doesn't require fine proportional tuning, standard often holds up fine. If your press cycle demands consistent, repeatable force profiling, stepping up to high or ultra is worth the cost difference.

Tell us what you need and we'll get back to you.

Fields marked * are required.