A cast iron vane pump built for demanding industrial hydraulic circuits, the Vickers V20F 1P13P 38C8H 22 is part of the well-established V20 Series from Vickers by Danfoss/Eaton. Its pressure-balanced, modular 12-vane design keeps noise and flow pulsation low, making it a practical choice for applications where consistent output matters.
With a flow rate of approximately 99.7 litres per minute and Buna-N seals, this pump suits a broad range of applications including metal cutting machinery, plastic injection molding equipment, dump trucks, and wheel loaders, as well as oil and gas service. The modular design also supports a wide range of available displacements, allowing flexibility across different circuit requirements.
SKU: 02-141854-3
Supplier Part Number (MPN): 02-141854-3
Alternate Part Numbers: V20F1P13P38C8H22
Loading related products…
Specifications
Alternate Part Numbers
Alternate Part NumberMINO-00900X44238, Alternate Part Number V20F1P13P38C8H22
Application
Oil and Gas, Metal Cutting, Dump Truck, Wheel Loader, Plastic Injection Molding
Brand
DANFOSS POWER SOLUTIONS II LLC (VICKERS)
Brand
Vickers
Pack Size
1.00
UOM
EA
Features
Pressure-balanced, modular 12-vane design|Reduces noise and flow pulsation|Wide range of available displacements
Flow Rate1
99.6721152 litre per minute
ICC
Hydraulic - Vane Pumps
Language
English
Product Material
Cast Iron
Product Width
5.12
Seal Material
Buna-N
Series
V20
Special Features
None
Sub Brand
Vickers
Supplier Part Number
02-141854-3
Product Weight
18.00 lbs
Product Questions & Answers (2)
Question by: Jean G on Apr 13, 2025, 6:33 AM
If I'm running this Vickers V20F pump on a dump truck, what kind of flow rate am I lookin' at?
Answer by: Customer Support on Apr 14, 2025, 2:30 PM
Flow rate on this unit is about 99.7 liters per minute, making it suitable for a dump truck application.
Question by: Lyle H on Mar 13, 2026, 9:21 AM
Flow rate on this one says roughly 99.7 litres per minute, that about right for metal cutting circuits runnin continuous cycles?
Answer by: Customer Support on Mar 14, 2026, 11:08 AM
For metal cutting machinery, that flow rate holds up well in continuous industrial circuits. The pressure-balanced vane design helps keep output steady, which matters when you need consistent performance across a full shift without a lot of pulsation throwing off your cuts. The 12-vane configuration specifically helps smooth out flow, so what you're seeing on the spec is what you can expect in practice under normal operating conditions.
