Skip to the beginning of the images gallery

VICKERS DGMC 3 AB GW 41

Description & Features

The Vickers DGMC 3 AB GW 41 is a system stak valve suitable for applications such as die casting and foundry, machine tools, marine and offshore, presses, primary metal, paper, test equipment and simulation, and turbine control (wind, steam, water).

This Eaton Vickers valve helps reduce installation costs, eliminates external leakage, and boosts resistance to contamination. It has a flow rate of 60 liters per minute and uses Buna-N seals.

SKU: 02-147185

Supplier Part Number (MPN): 02-147185

Specifications

Alternate Part Numbers Alternate Part Number MINO-00900X46414	Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Reduce installation costs\|Eliminate external leakage\|Boost resistance to contamination	Flow Rate1 60 litre per minute	ICC IV Directional Control Valves	Language English	Net Pack Quantity Units EA	Product Width 1.87	Seal Material Buna-N	Special Features None	Sub Brand Vickers	Supplier Part Number 02-147185	Product Weight 2.90 lbs

Product Questions & Answers (3)

Question by: Brett W on Aug 17, 2025, 12:04 PM

got a systemstak setup already. is this DGMC-3 41 design valve meant to help cut down on leak points or am i thinking of something else

Answer by: Customer Support on Aug 18, 2025, 4:49 PM

In a SystemStak stack, the DGMC-3 41 design valve is used to reduce installation costs and eliminate external leakage by keeping the function in the stack instead of relying on extra external hydraulic connections.

Question by: Harvey W on Aug 13, 2025, 3:32 PM

flow rate on this valve, is 60 liters per minute the max it'll handle or just the rated continuous flow?

Answer by: Customer Support on Aug 15, 2025, 6:01 AM

Sixty liters per minute is the rated flow for this valve. Running right at the rated flow continuously puts you at the edge of the design envelope, so most folks size their system to stay a bit below that ceiling during normal operation. If your application regularly pushes against that number, it's worth accounting for pressure drop and heat buildup in your circuit design.

Question by: Dwayne F on Dec 11, 2025, 5:51 PM

Would this stack valve be a good fit for a die casting machine?

Answer by: Customer Support on Dec 13, 2025, 12:16 PM

Yes, this Vickers DGMC-3 valve is suitable for die casting and foundry applications, according to the listed applications.