Designed for demanding industrial applications, the Vickers 20V11A 151A22R is a V Series vane pump built on an innovative intra-vane cartridge design that supports reduced noise levels and strong volumetric efficiency. The pump body is constructed from cast iron, with Buna-N seals suited to standard hydraulic fluid compatibility requirements.
With a flow rate of approximately 121 litres per minute, this unit is well-suited for use in metal cutting machinery, plastic injection molding equipment, dump trucks, wheel loaders, and oil and gas applications. It is part of the Vickers VHO series, manufactured under the Vickers brand by Eaton/Danfoss.
SKU: 02-151508-1
Supplier Part Number (MPN): 02-151508-1
Alternate Part Numbers: 20V11A151A22R
Loading related products…
Specifications
Alternate Part Numbers
Alternate Part Number20V11A151A22R, Alternate Part Number MINO-00900X45375
Application
Oil and Gas, Metal Cutting, Dump Truck, Wheel Loader, Plastic Injection Molding
Is this a direct swap for a 20V11A 151A220 pump? Just wanna be sure before I order.
Answer by: Customer Support on Jul 27, 2025, 2:24 PM
This V Series vane pump carries the alternate part number 20V11A151A22R, so it should serve as a direct replacement.
Question by: Kurt P on Nov 1, 2025, 3:19 PM
flow rate on this thing is listed around 121 liters per minute, that enough to run a plastic injection molding setup without starving the circuit?
Answer by: Customer Support on Nov 3, 2025, 9:38 AM
For most plastic injection molding systems, 121 liters per minute is a solid output. The 20V11A runs on a V Series vane pump platform with strong volumetric efficiency built into the intra-vane cartridge design, so you're not losing much flow to internal slippage. Whether it fully meets your system's demand depends on your specific machine requirements, but the flow figure and the application listing both point to this being a well-matched fit for that kind of work.
