SAME DAY SHIPPING
— Order by 2pm EST.
Toggle Nav
Cart
Search
main product photo

Vickers-KCG 3 L350D Z M U H1 10P15 T10

Ask A Question

Description & Features

Designed for precision flow control in demanding industrial environments, the Vickers-KCG 3 L350D Z M U H1 10P15 T10 is a direct-acting proportional valve rated at 5 litres per minute. It is part of the Vickers KCG-3 10 Design series, available in three performance levels, ultra, high, and standard, allowing it to be matched to a wide range of application requirements without over-specifying.

Plug-and-play functionality reduces commissioning time, making this valve well-suited for integration into machine tool systems, press equipment, turbine control (wind, steam, and water), and marine or offshore installations. Additional application areas include die casting and foundry, primary metal processing, paper manufacturing, and test equipment and simulation setups.

SKU: 02-156653

Supplier Part Number (MPN): 02-156653

Specifications

Brand
Vickers by Danfoss
Actuator Type
Solenoid
Build Orientation
Solenoid at A Port End
Design
10 Series
Dimensions
6.28 in L x 1.88 in W x 3.42 in H
Domestic/Import
Domestic
Feedback Sensor
Without Feedback Sensor
Media
Anti-Wear Hydraulic Oil, Non-Alkyl Based Phosphate Ester
Nominal Size
#03
Number of Stages
1
On Board Electronics
Without On Board Electronics
Performance
Standard
ProFX Compatible
Without ProFX Compatible
Reducer Module
Without Reducer Module
Reverse Flow Check
Without Reverse Flow Check
Seal Material
FKM
Segment Code
C
Series
KCG3 Series
Valve Mount Type
Subplate

Product Questions & Answers (2)

Question by: Cheryl R on Dec 5, 2025, 7:58 AM
got a press setup that needs real tight flow control, will 5 litres per minute be enough or is this valve gonna be a bottleneck?
Answer by: Customer Support on Dec 6, 2025, 5:33 PM
For press applications that call for precise, low-volume flow regulation, 5 litres per minute is right in the wheelhouse of what this valve handles. It's a direct-acting proportional valve, so the control response is immediate rather than pilot-dependent, which tends to matter a lot in press work where you want consistent, repeatable movement. If your system demand runs higher than 5 LPM, this particular unit would be undersized, but for fine metering at lower flow rates it fits that need well.
Question by: Pete F on Jan 5, 2026, 6:10 AM
Reckon this'd be alright for runnin' a small press, like for stamping metal?
Answer by: Customer Support on Jan 6, 2026, 1:23 PM
Application-wise, yes, this Vickers valve should do the trick for press equipment. It's also used in die casting, foundries, and primary metal processing, so it's definitely suited for industrial hydraulic press applications.

Tell us what you need and we'll get back to you.

Fields marked * are required.