Skip to the beginning of the images gallery

Vickers DG4V 3S 8C V M U B5 61 EN21

Description & Features

Designed for three- or four-way directional control in demanding industrial hydraulic circuits, the Vickers DG4V 3S 8C V M U B5 61 EN21 is a single-stage directional control valve suited to a broad range of applications including machine tools, presses, die casting, marine and offshore systems, primary metal processing, test and simulation equipment, and turbine control.

The valve supports a flow rate of 40 litres per minute and features Buna-N seals, making it appropriate for standard hydraulic fluid compatibility requirements. Mounting follows industry-standard surface patterns, simplifying integration into existing hydraulic assemblies.

Part of the well-established DG4V-3 design series from Vickers by Danfoss/Eaton, this valve is available in thousands of model configurations to address varying circuit requirements across industrial sectors.

SKU: 02-342402

Supplier Part Number (MPN): 02-342402

Specifications

Alternate Part Numbers Alternate Part Number MINO-00900X49583	Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Three- or four-way directional control\|Easily mountable on industry-standard surfaces\|Thousands of models to suit all applications	Flow Rate1 40 litre per minute	ICC IV Directional Control Valves	Language English	Net Pack Quantity Units EA	Product Width 1.80	Seal Material Buna-N	Special Features None	Sub Brand Vickers	Supplier Part Number 02-342402	Product Weight 4.00 lbs

Product Questions & Answers (2)

Question by: Dale T on Nov 21, 2025, 6:45 PM

What kind of machinery is this valve typically hooked up to?

Answer by: Customer Support on Nov 23, 2025, 10:57 AM

It's designed for directional control on hydraulic systems, so you'll find it on machine tools, presses, die casting equipment, marine and offshore setups, metal processing, test and simulation rigs, and even turbine controls.

Question by: Patty M on Nov 7, 2025, 12:55 PM

Flow rate on this one is listed at 40 LPM, that enough for a press circuit running moderate tonnage, or am I gonna need something beefier?

Answer by: Customer Support on Nov 8, 2025, 6:08 PM

For a lot of press applications running standard hydraulic circuits, 40 litres per minute handles the job without issue. The DG4V-3 series was built with press work in mind alongside machine tools and die casting setups, so moderate tonnage press circuits are well within its wheelhouse. If your system demands significantly higher flow, you'd want to look at a larger valve in the DG4V lineup since this one is rated at 40 LPM and that's the ceiling to work within.