Designed for machine tool and general industrial applications, the Vickers DGMX2-3-PP-BW-S-40-EN13 is a SystemStak directional control valve built to simplify multi-valve installations while reducing external leakage points. Its stacked valve architecture eliminates the need for individual manifold connections between components, lowering installation complexity and improving resistance to contamination.
Rated for flows up to 60 litres per minute, the valve uses Buna-N seals suited to standard hydraulic fluid compatibility requirements. At 2.82 inches in width, it integrates efficiently into compact valve stacks. This is a Vickers by Danfoss/Eaton product, carrying the reliability expectations associated with that product line across demanding industrial duty cycles.
SKU: 02-396729
Supplier Part Number (MPN): 02-396729
Alternate Part Numbers: DGMX2-3-PP-BW-S-40-EN13
Loading related products…
Specifications
Alternate Part Numbers
Alternate Part NumberDGMX2-3-PP-BW-S-40-EN13, Alternate Part Number MINO-00900X52269
Application
Machine tool and multiple industrial applications
Brand
Danfoss (Power Solutions II LLC)
Brand
Vickers
Pack Size
1.00
UOM
EA
Features
Reduce installation costs|Eliminate external leakage|Boost resistance to contamination
Flow Rate1
60 litre per minute
ICC
IV Directional Control Valves
Language
English
Net Pack Quantity Units
EA
Product Width
2.82
Seal Material
Buna-N
Special Features
None
Sub Brand
Vickers
Supplier Part Number
02-396729
Product Weight
2.20 lbs
Product Questions & Answers (2)
Question by: Lynn O on Jan 30, 2026, 9:44 PM
I'm looking at stacking a couple of these. What kinda flow rate am I lookin' at?
Answer by: Customer Support on Feb 1, 2026, 12:52 PM
Rated for flows up to 60 litres per minute, this directional control valve is a SystemStak design that will let you simplify multi-valve installations.
Question by: Larry E on Jan 29, 2026, 4:31 PM
flow rate on this thing tops out at 60 LPM -- is that enough for most machine tool setups or does it run tight on bigger systems?
Answer by: Customer Support on Jan 31, 2026, 8:01 AM
For standard machine tool applications, 60 litres per minute covers a solid range of typical operating demands. Where it gets tight is in higher-volume systems running multiple actuators simultaneously at elevated flow requirements. If your circuit stays within that ceiling, the valve handles it without issue. Going beyond that threshold is where you'd need to look at a different size.
