Skip to the beginning of the images gallery

VICKERS-DGMC2-5-AT-FW-BT-FW-B-30-EN422

Description & Features

The VICKERS-DGMC2-5-AT-FW-BT-FW-B-30-EN422 is a system stak valve designed for demanding applications such as die casting and foundry work, machine tools, marine and offshore environments, presses, primary metal production, paper manufacturing, test equipment and simulation, and turbine control (wind, steam, and water).

This Vickers valve reduces installation costs and eliminates external leakage, while boosting resistance to contamination. It features a 120 liter per minute flow rate and utilizes Buna-N seals. The valve body has a width of 2.82 inches.

SKU: 02-400607

Supplier Part Number (MPN): 02-400607

Specifications

Alternate Part Numbers Alternate Part Number MINO-00900X52673	Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Reduce installation costs\|Eliminate external leakage\|Boost resistance to contamination	Flow Rate1 120 litre per minute	ICC IV Directional Control Valves	Language English	Product Width 2.82	Seal Material Buna-N	Special Features None	Sub Brand Vickers	Supplier Part Number 02-400607	Product Weight 7.90 lbs

Product Questions & Answers (2)

Question by: Denise R on Aug 24, 2025, 9:38 PM

Flow rate on this one is listed at 120 liters per minute, is that enough for press and die casting work, or is that on the lower end for those applications?

Answer by: Customer Support on Aug 26, 2025, 9:33 PM

For die casting and press applications, 120 liters per minute is a solid working flow rate and falls well within the range those use typically run. This valve was built with exactly those environments in mind, so it's not a stretch to say it fits naturally there. The Buna-N seals hold up well against the fluid types common in those settings, and the design cuts down on external leakage which matters a lot when you're running high-cycle press work or dealing with the heat and mess of a foundry floor.

Question by: Keith C on Sep 25, 2025, 7:09 PM

Is this valve something that could stand up to the kind of hydraulic fluid contamination you get in a metal foundry?

Answer by: Customer Support on Sep 27, 2025, 7:19 AM

It's designed with boosted resistance to contamination in mind, especially for demanding applications like die casting and foundry work.