Skip to the beginning of the images gallery

VICKERS DG4V-3-2A-M-FWL-B6-60-EN75-P10

Description & Features

A solenoid-operated directional control valve rated for flows up to 80 litres per minute, the Vickers DG4V-3-2A-M-FWL-B6-60-EN75-P10 is built for demanding industrial hydraulic circuits across a broad range of sectors. Buna-N seals provide reliable fluid compatibility in standard hydraulic oil environments, and the B6 porting pattern supports straightforward manifold or subplate mounting integration.

Suited for use in machine tool, press, primary metal, and die casting and foundry applications, this valve also sees deployment in marine and offshore systems, turbine control for wind, steam, and water installations, and test equipment and simulation rigs. The FWL wet armature solenoid configuration and EN75 electrical designation reflect a design intended for consistent performance across varied duty cycles and installation environments.

SKU: 02-401079

Supplier Part Number (MPN): 02-401079

Specifications

Alternate Part Numbers Alternate Part Number MINO-00900X52691	Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Flow Rate1 80 litre per minute	ICC IV Directional Control Valves	Language English	Net Pack Quantity Units EA	Product Width 2	Seal Material Buna-N	Special Features None	Supplier Part Number 02-401079	Product Weight 3.50 lbs

Product Questions & Answers (2)

Question by: Travis S on Aug 19, 2025, 8:32 PM

Flow rating on this one says 80 litres per minute, that good enough for a press circuit running moderate duty, or is it gonna be stretched thin?

Answer by: Customer Support on Aug 21, 2025, 6:16 AM

For a moderate-duty press circuit, 80 litres per minute gives you solid headroom without pushing the valve near its limits. This is actually one of the listed application areas for that valve, so it's a reasonable fit for that kind of work. Just make sure your system demand stays comfortably below the rated flow to keep things running smooth over time.

Question by: Kent W on Sep 4, 2025, 10:07 AM

Can this valve handle the kind of flow rates you'd see in a typical machine tool setup?

Answer by: Customer Support on Sep 5, 2025, 12:23 PM

With a flow rate of up to 80 liters per minute, it's rated to handle the demands of machine tool applications, as well as presses, primary metal, and even die casting and foundry environments.