Skip to the beginning of the images gallery

VICKERS DARV-W-10-K-10/315

Description & Features

Designed for demanding industrial environments, the Vickers DARV-W-10-K-10/315 is a DARV Series pressure control valve rated for flow up to 120 litres per minute. Its moisture-resistant construction and Buna-N seals make it well suited to applications where fluid compatibility and environmental resilience matter.

The plug-and-play design simplifies installation and integration into existing hydraulic circuits. This valve is applicable across a broad range of industries, including machine tool, press, primary metal, die casting and foundry, marine and offshore, test equipment and simulation, and turbine control for wind, steam, and water systems.

SKU: 02-413475

Supplier Part Number (MPN): 02-413475

Specifications

Alternate Part Numbers Alternate Part Number MINO-00900H95607	Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Plug-and-play design\|High-performance features\|Moisture resistant	Flow Rate1 120 litre per minute	ICC IV Pressure Valves	Language English	Net Pack Quantity Units EA	NMFC 77.50	Product Width 1.49	Seal Material Buna-N	Sub Brand Vickers	Supplier Part Number 02-413475	Product Weight 1.10 lbs

Product Questions & Answers (2)

Question by: Ralph S on Jan 19, 2026, 4:15 PM

flow rate on this valve is listed at 120 litres per minute -- is that enough for press and die casting setups or is it usually on the lower end for those applications?

Answer by: Customer Support on Jan 21, 2026, 6:30 AM

For press and die casting work, 120 litres per minute puts this valve solidly in a usable range for a wide variety of circuits. Those applications can vary a lot depending on cylinder bore, stroke speed, and system demand, but this flow capacity covers most mid-range industrial setups in those categories. If your system is running particularly high-volume cycles, you'd want to verify your peak flow demand against that number, but for standard press and die casting hydraulic circuits, it holds up well.

Question by: Shane M on Jul 23, 2025, 8:34 AM

Can this handle hydraulic fluid with some moisture in it, or do I need to be real careful about that?

Answer by: Customer Support on Jul 24, 2025, 6:54 PM

It's made to resist moisture, and it uses Buna-N seals, which hold up well when there's some fluid incompatibility.