SAME DAY SHIPPING
— Order by 2pm EST.
Toggle Nav
Cart
Search
main product photo

Vickers F3 V10 1P2P 1A20

Ask A Question

Description & Features

Designed for demanding industrial applications, the Vickers F3 V10 1P2P 1A20 is a cast iron vane pump built around a pressure-balanced, modular 12-vane design that reduces noise and minimizes flow pulsation during use. With a flow rate of approximately 28.07 litres per minute and Viton seals for reliable fluid compatibility, this pump is well-suited to hydraulic circuits where consistent output and durability are priorities.

Part of the Vickers V10 Series by Danfoss/Eaton, this pump serves a broad range of industrial applications including metal cutting machinery, plastic injection molding equipment, dump trucks, wheel loaders, and oil and gas service equipment. The modular design supports a wide range of available displacements, offering flexibility across different system configurations without requiring extensive modifications.

SKU: 396515-1

Supplier Part Number (MPN): 396515-1

Specifications

Brand
Vickers by Danfoss
Cartridge Type
20 Design
Dimensions
6.3 in L x 5.12 in W x 4.35 in H
Drive Shaft Type
Straight Keyed
Housing Material
Iron
Inlet Type
NPT
Maximum Operating Pressure
2500 psi
Mounting Type
Flanged
Outlet Cover Port Orientation
Opposite to Inlet Port
Outlet Type
NPT
Rotation Direction
Opposite Inlet
Seal Material
FKM
Series
V10 Series
Vane Type
Balanced

Product Questions & Answers (2)

Question by: Todd W on Jun 30, 2025, 8:51 PM
Will this thing hold up okay in a metal cutting shop?
Answer by: Customer Support on Jul 2, 2025, 9:30 AM
Designed for demanding industrial use, this Vickers vane pump is definitely suitable for the environment you describe. Its cast iron construction and Viton seals should offer good durability and fluid compatibility in that setting.
Question by: Scott T on Jul 29, 2025, 7:49 PM
pump puts out right around 28 liters a minute -- is that consistent across the operating range or does it drop off under load?
Answer by: Customer Support on Jul 31, 2025, 2:21 PM
At full flow, you're looking at approximately 28.07 litres per minute from this unit. The pressure-balanced vane design is specifically built to keep flow pulsation low, so output stays relatively steady rather than surging and dropping. That's actually one of the reasons this pump gets used in metal cutting and injection molding setups where consistent hydraulic pressure matters throughout the cycle.

Tell us what you need and we'll get back to you.

Fields marked * are required.