Designed for demanding fluid power applications, the Vickers V10F 1P6P 38C6G 20 is a single-stage vane pump built around a pressure-balanced, modular 12-vane design that reduces noise and flow pulsation during operation. The cast iron housing contributes to structural durability in high-cycle industrial environments, while Buna-N seals provide reliable fluid compatibility with standard hydraulic oils.
With a flow rate of approximately 56.2 litres per minute, this pump is well suited to metal cutting machinery, plastic injection molding equipment, dump trucks, wheel loaders, and oil and gas applications. The V10 series offers a wide range of available displacements, making it a practical choice where consistent volumetric output and quiet operation are priorities.
SKU: 430507-3
Supplier Part Number (MPN): 430507-3
Alternate Part Numbers: V10F1P6P38C6G20
Loading related products…
Specifications
Alternate Part Numbers
Alternate Part NumberMINO-00900H50235, Alternate Part Number V10F1P6P38C6G20
Application
Oil and Gas, Metal Cutting, Dump Truck, Wheel Loader, Plastic Injection Molding
Brand
DANFOSS POWER SOLUTIONS II LLC (VICKERS)
Brand
Vickers
Pack Size
1.00
UOM
EA
Features
Pressure-balanced, modular 12-vane design|Reduces noise and flow pulsation|Wide range of available displacements
Flow Rate1
56.24355072 litre per minute
ICC
Hydraulic - Vane Pumps
Language
English
Product Material
Cast Iron
Product Width
5.12
Seal Material
Buna-N
Series
V10
Special Features
None
Sub Brand
Vickers
Supplier Part Number
430507-3
Product Weight
15.00 lbs
Product Questions & Answers (1)
Question by: Wayne M on Mar 6, 2026, 1:21 PM
flow rate on this pump is listed around 56 liters per minute, that hold up in oil and gas applications or is it better suited for lighter duty stuff like plastic injection molding?
Answer by: Customer Support on Mar 8, 2026, 10:40 AM
At roughly 56 liters per minute, this pump handles both ends of that spectrum just fine. Oil and gas use run it, and so do plastic injection molding setups. The pressure-balanced 12-vane design keeps flow pulsation low, which matters a lot in molding applications where consistency is everything. For oil and gas, the cast iron housing holds up well against the demands of that environment. It's a versatile unit across all five of those listed applications.
