Skip to the beginning of the images gallery

VICKERS PCGV 8A 1 10

Description & Features

Rated for flow up to 300 litres per minute, this Eaton Vickers check valve is built for demanding industrial hydraulic circuits where pressure stability and leak-free performance are critical. The VICKERS PCGV 8A 1 10 is a 10-design unit in the PCGV-8 series, featuring Buna-N seals suited to a broad range of hydraulic fluids and operating conditions.

Suitable for high-cycle and high-load environments, this valve is used across die casting and foundry equipment, machine tools, marine and offshore systems, presses, primary metal processing, test and simulation rigs, and turbine control applications including wind, steam, and water turbines. Minimal maintenance requirements and consistent sealing performance make it a practical choice for both new builds and replacement installations.

SKU: 615075

Supplier Part Number (MPN): 615075

Alternate Part Numbers: PCGV8A110

Specifications

Alternate Part Numbers Alternate Part Number PCGV8A110	Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Stability under pressure\|Minimal maintenance\|Stop leaks before they start	Flow Rate1 300 litre per minute	ICC IV Directional Control Valves	Language English	Net Pack Quantity Units EA	Product Width 4.10	Seal Material Buna-N	Special Features None	Sub Brand Vickers	Supplier Part Number 615075	Product Weight 13.00 lbs

Product Questions & Answers (2)

Question by: Ross M on Mar 3, 2026, 11:53 AM

flow rate on this check valve -- is 300 liters per minute enough for press applications or is that gonna be cutting it close?

Answer by: Customer Support on Mar 4, 2026, 4:03 PM

For press applications, 300 litres per minute puts the PCGV-8A squarely in the capable range. Press systems are listed as a supported application for this valve, so it's not a stretch to run it in that environment. Whether 300 LPM covers your specific circuit depends on your system's peak demand, but the valve itself isn't the limiting factor for most press setups.

Question by: Marvin E on Sep 12, 2025, 8:29 AM

Will this check valve hold up in a die casting application, or is it meant for lighter duty?

Answer by: Customer Support on Sep 14, 2025, 6:50 AM

Application-wise, this Vickers PCGV-8 valve is solid for die casting and foundry work, but it's also commonly used in machine tools, marine/offshore setups, presses, primary metal processing, paper mills, and even test equipment.