Skip to the beginning of the images gallery

VMQ22525S050010A00100AAAAEANR00A032

Description & Features

The Vickers by Danfoss VMQ22525S050010A00100AAAAEANR00A032 vane pump is designed for demanding applications including metal cutting, oil and gas, plastic injection molding, dump trucks, and wheel loaders.

This Vickers VMQ Series Vane Pump features a unique wafer plate design to deliver high pressure and low noise performance. Constructed from durable cast iron with Buna-N seals, the pump offers a flow rate of 21.46001664 liters per minute. It is adaptable for single, double or triple pump configurations.

SKU: 711-0297-032

Supplier Part Number (MPN): 711-0297-032

Specifications

Alternate Part Numbers Alternate Part Number MINO-00900X76587	Application Oil and Gas, Metal Cutting, Dump Truck, Wheel Loader, Plastic Injection Molding	Brand DANFOSS POWER SOLUTIONS II LLC (VICKERS)	Brand Danfoss Power Solutions	Pack Size 1.00	UOM EA	Features Highest pressures, lowest noise\|Unique wafer plate design\|Single, double or triple pump	Flow Rate1 21.46001664 litre per minute	ICC Hydraulic - Vane Pumps	Language English	Net Pack Quantity Units EA	NMFC 77.50	Product Material Cast Iron	Product Width 6.85	Seal Material Buna-N	Series VMQ	Special Features None	Sub Brand Vickers	Supplier Part Number 711-0297-032	Product Weight 81.00 lbs

Product Questions & Answers (3)

Question by: Lance A on May 17, 2025, 12:41 PM

got a hydraulic setup that’s kinda tight on space. is this VMQ pump only a single, or can it be stacked up?

Answer by: Customer Support on May 19, 2025, 8:03 AM

Built to be adaptable, the VMQ Series vane pump can be used in single, double, or triple pump configurations, so it can be set up as a multi-section stack when you need more than one circuit.

Question by: Kirk L on Jan 6, 2026, 7:49 PM

So, this thing can handle oil and gas stuff, right? What else is it good for?

Answer by: Customer Support on Jan 7, 2026, 9:05 PM

Absolutely. This vane pump is also well-suited for metal cutting, plastic injection molding, and even heavy-duty applications like dump trucks and wheel loaders.

Question by: Stan P on Jul 30, 2025, 11:37 AM

been running a vane pump setup on our injection molding line and looking at swapping in this Vickers VMQ unit, does the cast iron housing hold up alright in that kind of continuous cycle environment?

Answer by: Customer Support on Aug 1, 2025, 6:17 AM

Cast iron is a solid choice for injection molding duty. It handles the pressure demands well, and this pump is specifically listed for plastic injection molding applications, so it's not a stretch to say it was built with that kind of workload in mind. The Buna-N seals are compatible with standard hydraulic oils, which is what most molding lines run. Flow comes in at just over 21 liters per minute, so just make sure that lines up with what your circuit requires before pulling the trigger.