Rated for flow up to 80 litres per minute, the Vickers DG4V 3 6N M U B6 60 is a single-stage directional control valve designed for demanding industrial hydraulic circuits. With Buna-N seals and a 20-watt solenoid, it suits a wide range of fluid power system requirements across both fixed and mobile environments.
This valve supports three- or four-way directional control and mounts to industry-standard subplate surfaces, simplifying integration into existing manifold assemblies. Typical applications include machine tool circuits, press systems, die casting and foundry equipment, primary metal and paper processing, turbine control for wind, steam, and water installations, marine and offshore systems, and test and simulation equipment. The Eaton Vickers design reflects a broad application range within a compact, well-established valve envelope.
SKU: 870290
Supplier Part Number (MPN): 870290
Alternate Part Numbers: DG4V36NMUB660
Loading related products…
Specifications
Alternate Part Numbers
Alternate Part NumberDG4V36NMUB660, Alternate Part Number MINO-00900X98544
Application
Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)
Brand
Danfoss (Power Solutions II LLC)
Brand
Vickers
Pack Size
1.00
UOM
EA
Features
Three- or four-way directional control|Easily mountable on industry-standard surfaces|Thousands of models to suit all applications
Flow Rate1
80 litre per minute
ICC
IV Directional Control Valves
Language
English
Product Width
1.80
Seal Material
Buna-N
Special Features
None
Sub Brand
Vickers
Supplier Part Number
870290
Wattage
20
Product Weight
4.00 lbs
Product Questions & Answers (1)
Question by: Jean J on May 20, 2025, 7:37 PM
flow rate on this unit -- is 80 LPM enough for most press applications or do I need to be looking at something bigger?
Answer by: Customer Support on May 22, 2025, 6:13 AM
For a good number of press setups, 80 liters per minute gets the job done without issue. Where you might run short is on larger high-tonnage presses with fast cycle demands pulling more flow through the circuit. If your press falls in the mid-range, this valve handles it fine. The DG4V-3 series is also used across die casting, primary metal, and test equipment work, so the flow rating was built with varied industrial loads in mind.
