The DANFOSS Power Solutions (II LLC Aeroquip)a Double Wire SAE 100R16 Hose GH781-16R150 is designed for hydraulic system service with petroleum and water-based fluids, making it suitable for general industrial service. It features a 1-inch inner diameter and can handle pressures up to 3000 PSI, meeting or exceeding DIN requirements at a 1/2 SAE bend radius.
Constructed with a synthetic rubber tube, double wire braid reinforcement, and a black synthetic rubber cover, this hose offers exceptional durability and performance. The premium abrasion resistance and conductive properties ensure reliable operation even in challenging environments.
The hose has an impulse cycle life of 600000 B7, a minimum working temperature of -50deg;F, and a temperature range from -40deg;F to +212deg;F. Its minimum bend radius is 6 inches and the reel quantity ranges from 125-200 feet.
ECCN: EAR99
Supplier Part Number: GH781-16R150
Loading related products…
Specifications
Brand
Aeroquip® by Danfoss
Abrasion Resistance
Standard
Conditional Temp Range
-40 to 257 deg F Intermittently
Cover Material
Nitrile
Dash Size
16
For Use With
TTC/Z Series Hose Fittings
grp Construction
Synthetic Rubber Tube, 2-Wire Braided Reinforcement, Black Synthetic Rubber Cover
i got a system running right at 3000 psi pretty regular. what kind of burst rating does this hose have to handle spikes
Answer by: Customer Support on Jan 15, 2026, 9:34 AM
Spikes are covered up to 12000 PSI before the line fails. The maximum operating pressure is strictly rated for 3000 PSI for regular use so you have a solid four to one safety factor built in for those sudden surges.
Question by: Kirk G on Aug 21, 2025, 8:42 PM
hose rated for 3000 PSI, that hold up on continuous hydraulic runs or is that more of a peak number?
Answer by: Customer Support on Aug 23, 2025, 7:26 AM
3000 PSI is the working pressure rating, so it's built to handle that load in regular service, not just momentary spikes. The burst pressure on this hose is 12,000 PSI, which gives you a 4:1 safety factor over the working rating. For continuous hydraulic duty, that working pressure figure is what you're operating against, and this hose is built to meet or exceed SAE 100R16 and DIN requirements at those levels. The double wire braid reinforcement is what carries that load, so it's not a one-time peak spec.
Question by: Warren T on Aug 1, 2025, 8:43 AM
got a tight spot to snake a 1 inch hydraulic line through. how tight can this GH781 hose bend without kinkin it
Answer by: Customer Support on Aug 2, 2025, 11:19 AM
Minimum bend radius on this hose is 6 inches. If you route it tighter than that, you are more likely to stress the reinforcement and shorten hose life.